Datapath VSN990 Uživatelský manuál stáhnout pdf (Strana 9)

Use of the SBC’s onboard graphics adaptor

Onboard Graphics Adaptor used as Control Screen

The VSN990 is shipped with the BIOS congured to boot o the onboard graphics device. This output can

then be used as the control screen for a typical wall conguration.

To set the system to boot on the onboard graphics device (“Internal Graphics Device” - IGD), enter setup

from the boot screen by pressing <DEL> as prompted.

In the BIOS setup utility select:

Chipset>North Bridge Conguration>Initiate Graphic Adapter - [IGD]

Chipset>North Bridge Conguration>PEG Port Conguration>PCI Express Port - [Auto]

Onboard Graphics Adaptor Disabled

If you do not require a control screen, then you should disable the integrated graphics as described below.

Connect a monitor to the onboard graphics device output and enter setup from the boot screen by

pressing <DEL> as prompted.

In the BIOS setup utility select:

Fig.5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Žádné komentáře

Datapath VSN990 Uživatelský manuál Strana 9